Skip to main content

Relay Circuit: Arduino + Lamp

 

Simple Relay circuit made for Arduino to control a lamp with a photocell. It uses a simple digital pin out to send a signal to trigger the relay and power on the lamp. Its similar to the blink setup code but instead of a small LED you are controlling another object with a larger voltage. 











Comments

Post a Comment

Popular posts from this blog

PO1: The Bespoke Object, Refining.

Week 2:  I pretty much spent the entire week modifying the model. Mostly to make it usable for patterning, and maybe to also have it ready for animation, but I might take a different route on that. It was possible to just use the draft model, but working from experience anything that is curved on an inflatable would have a tendency to straighten. Because air volume inside the soft structure would have a tendency to push on all directions. To mitigate this, I instead opted for a flatter structure that resembles a crocodile more than a salamander. I do appreciate the whimsy of the initial draft.   Tools Used: Nomad Sculpt, Blender, Rhino, Cozy Blanket. When designing models I tend to jump between software, Its easier to design soft and organic structures using mesh based modelling or sculpting. And I happen to have a variety of choices to choose from, each with a with a specific strength but none can do it best.  Below is my workflow on Nomad Sculpt which is an I...
Post a Comment
Read more

Interactive Circuit: LED Panner

 MADT 304 week 2: In this week we where tasked with wiring up an interactive circuit that can control multiple LEDs.  Class discussion also introduced the use of "if" statements which allow the use of Boolean logical  operators(>/</>=/<=/==/&&) in order to filter data flow or command events. Using a Potentiometer and mapping out thresholds with if  statements we can pan LEDs.  Code :                                              float potMapped; void setup() { // put your setup code here, to run once: Serial.begin(9600); pinMode(8, OUTPUT); pinMode(10, OUTPUT); pinMode(11, OUTPUT); pinMode(12, OUTPUT); pinMode(13, OUTPUT); } void loop() { // put your main code here, to run repeatedly: potMapped = map(analogRead(A1), 0, 1023, 0, 255); if (analogRead(A1) >= 0 && analogRead(A1) = 250 && analogRead(A1) 420 && ...
Post a Comment
Read more

BLINK: Arduino

  Intro assignment for MADT 304   We make a LED blink, using a simple program directly from the Arduino.  Wiring Hookup: Output from PIN9 and 5v power and ground directly from the controller.  Code                                                int led = 9; void setup() { pinMode(led,OUTPUT); } void loop() { digitalWrite(led,HIGH); delay(500); digitalWrite(led,LOW); delay(500); }
Post a Comment
Read more